We supply the ASM E by DEK screen printer for solder paste deposition before component placement. It is a practical candidate when an SMT line needs a dedicated stencil printing station and the purchase depends on whether existing frames, blades and board support can be carried over. Start with the tooling you use most often and send measurements or photos of the pieces you plan to keep.
One production board can tell you more about setup than a bare machine demonstration. Choose a board with familiar print challenges, such as a flexible panel or small apertures near larger pads. Include the panel drawing, stencil frame size and your current squeegee setup. During a trial, check that the board is held consistently, the stencil registers to the board and the paste deposits remain acceptable across successive prints. If your operators run frequent changeovers, have them time a frame and board change as part of that trial.
For a unit that has already been in production, ask for a list of installed tooling, the cleaning assembly, the software revision and the supplied manuals or backups. If an old printer is being replaced, share the required transfer height, line direction and communications interface. We can match the quotation to those practical requirements and identify which accessories are included. This gives maintenance and purchasing teams the same equipment scope when the printer arrives.
| Buying consideration | Details to confirm |
|---|---|
| Tooling reuse | Frame dimensions and squeegee holders |
| Board fit | PCB dimensions, thickness and clamping needs |
| Installation | Conveyor height, direction and line interface |
| Delivery scope | Support tooling, cleaning assembly and software |






