The GKG GSK aligns a PCB to the stencil using vision and applies solder paste before component placement. The published board range is 50 × 50 mm to 400 × 340 mm. When adding or replacing a printer, check the board size together with the stencil frames already in use and the conveyor direction on your line.
| Print setup | GKG GSK published configuration |
|---|---|
| PCB dimensions | 50 × 50 mm minimum and 400 × 340 mm maximum |
| Stencil frame dimensions | 470 × 370 mm to 737 × 737 mm, with 20–40 mm frame thickness |
| Print speed setting | 10–200 mm/s |
| Print mode | Single or double stroke |
| Under-stencil cleaning | Dry, wet and vacuum methods listed for the GSK |
For an existing line, include the smallest and largest boards, a representative stencil frame and your typical underside support layout in the review. If you use solder paste inspection (SPI) feedback, specify which SPI system is on the line so the quote can reflect the installed interface and any required options. A print trial with one of your regular boards also gives your team a sample to check in its own SPI process.





