en
ori
alb
amh
ara
arm
aym
aze
bel
ben
bos
bul
bur
cs
dan
de
div
el
est
fil
fin
fra
gle
glg
grn
heb
hi
hkm
hrv
hu
ice
id
it
jp
kan
kin
kor
lao
lav
lit
ltz
lug
mao
may
mlt
nep
nl
nor
nya
orm
per
pl
pt
rom
ru
san
sk
som
spa
srp
swa
swe
tam
th
tr
ukr
urd
vie
wel
xho
With a specified wet print accuracy of ±20 μm at 6σ and Cpk ≥ 2.0, the MPM Momentum SMT Screen Printer combines precise stencil alignment with controlled solder paste deposition. The printer uses a vision system to identify PCB fiducials, correct alignment offsets and position the board relative to the stencil before printing.
Squeegee pressure and travel speed are programmable, allowing printing parameters to be adjusted for different solder paste formulations, stencil apertures and PCB layouts. Board support and controlled stencil separation also play an important role in maintaining consistent paste deposits, particularly around fine-pitch pads and densely populated PCB designs.
Especificaciones Técnicas rehegua
| Parámetro rehegua | Especificación rehegua |
|---|---|
| Wet Print Accuracy | ±20 μm @ 6σ, Cpk ≥ 2.0 |
| Printing Method | Automatic Stencil Printing |
| Sistema de Alineación rehegua | Vision-Based Fiducial Alignment |
| Squeegee Operation | Programmable Pressure and Speed |
| PCB Handling | Automatic Inline Transport |
| Stencil Separation | Controlled Separation |
| Printing Control | Programmable Print Parameters |
Vision Alignment and Solder Paste Printing
The Momentum printing cycle begins with PCB loading and positioning. Its vision system identifies fiducial marks on the PCB and stencil, then applies alignment corrections before the printing stroke.
During printing, solder paste is transferred through stencil apertures by the squeegee. Print speed, pressure and separation settings influence paste release, aperture filling and deposit consistency. These parameters are especially important for fine-pitch ICs, BGAs and small passive component pads, where variations in paste placement or volume can affect downstream assembly quality.
Stencil cleanliness and PCB support must also be considered when setting up the machine. Residual paste on the stencil underside can cause smearing or unintended deposits, while inadequate board support may affect stencil contact and paste transfer.
The Momentum family includes different machine generations and configurations. Printing area, conveyor arrangements, cleaning functions and installed options should therefore be matched to the specific machine rather than assumed to be identical across all Momentum models.
